1. First remove the old fluorescent tube, that is, there are springs on both sides, push it to one side with a little force, and you can come out.

2. Then remove the bracket cover, press the bottom plate with your left hand, hold the cover with your right hand and pull it up, you can remove the cover.

3. Then remove the electronic ballast, cut the input wire and output wire of the electronic ballast with diagonal pliers, and use a screwdriver to unscrew the screws that fix the electronic ballast, and the electronic ballast can be easily removed.

4. Then it is wiring. Connect the wires of the power grid and the incoming wires of the bracket ports, and wrap them with electrical tape.

5. Then cover the cover tightly, straighten the wrapped wires, and fix them in the slot of the bracket, hold the cover with both hands, and press down firmly to cover the cover.

6. Finally, install the LED light tube, align the wiring pins at both ends of the LED light tube with the installation seam of the bracket, and you can easily put it in and install it.